Nexaira

NEXWARE™ FEATURES

• XtremeSpeed® WAN Optimization
• WDS (Wireless Distribution System)
• Auto Failover w/Anti-Flap

NETWORK FEATURES

• Supports cable modems, DSL, wireline WAN, T1, & 3G
• WAN Auto Failover to 3G/4G for redundancy
• DHCP Server
• DNS Relay
• DMZ Host
• Auto-Reconnect
• Connect-on-demand
• Auto-Disconnect
• MAC access control
• Virtual server
• Dynamic DNS
• Static and Dynamic routing with RIP
• QoS

MANAGEMENT

• User Friendly Web GUI
• SNMP Management
• Remote control management
• Firmware upgradeable
• Auto connect to network
• Firmware upgradeable
• Set up wizard
• WDS (Wireless Distribution System)

WIRELESS STANDARD

• IEEE 802.11 b/g/n 2x2 mimo

• Up to 300 mbps Wi-Fi 100 mbps Ethernet

RANGE COVERAGE

• Tx/Rx power 18dbm/Per Cell
• indoors approx. 35-100 meters
• outdoors up to 100-300 meters

NUMBER OF CHANNELS

• 1-11 for N. America (FCC);1-11 for (DOC)
• 1-13 Europe (Except and ETSI)
• 1-14 (TELEC)

SECURITY

• 64-bit and 128-bit
• WEP encryption
• WPA encryption w/ WPA2 support
• NAT (Network Address Translation)

POWER

• Switching 12V
• 1.25A

WORKING ENVIRONMENT

• Temperature -10~70oC
• Humidity 10%~90%
• non-condensing

• 1*ExpressCard Slot
• 1*USB 2.0
• (1) 10/100 Wan (Software Configurable)
• (1) 10/100 LAN

ANTENNA

• Dual 3dbi Embedded Antennas

STANDARDS

• IEEE 802.11 b/g/n 2x2 mimo
• IEEE 802.3
• IEEE 802.3u

OS SUPPORTED

• Windows 95/98/ME/NT/2000/XP/VISTA/Windows 7
• Linux
• MAC

FREQUENCY

• 2.4 - 2.462 GHz
• CCK

COMPATIBILITY

• Works with all North American Carriers

NexAira's Router Hardware Setup

This video walks through the hardware setup of your Router. Learn how to setup 3G/4G, Landline, and Failover connections.

NexAira's i3 GUI™ Setup Wizard

This video walks through the Nexaira i3 GUI™ Setup Wizard. Learn how to change the necessary settings for your perticular internet setup. This video will teach you how to change your admin password, specify your connection type, and setup your wirless network.

Change DHCP Settings on Windows XP

If you are unable to establish a connection through your Ethernet cable, you may have to change your DHCP setings on your computer. If your internet protocol is set to a static IP address, and a static DNS address you will have to change it so the router can automaticly assign them. This video will walk you though how to change these settings on a Windows XP operating system.

Change DHCP Settings on Windows Vista

If you are unable to establish a connection through your Ethernet cable, you may have to change your DHCP setings on your computer. If your internet protocol is set to a static IP address, and a static DNS address you will have to change it so the router can automaticly assign them. This video will walk you though how to change these settings on a Windows Vista operating system.

Still having trouble? Try a submitting a Support Request Form. with one of our knowledgeable support technicians.