Nexaira

Use our easy set up wizards.

NexConnect® 3G/4G Wireless Router

NexAira® Business Class 3G/4G Router

The NexConnect® router supports both 3G Technologies: EVDO and GSM

Click here to see a compatibility chart of Carriers and Cards supported by the NexConnect® Router.

WEP, 802.1X, WPA-PSK/WPA-PSK2, WPA/WPA2

Here are some common settings for a number of providers:

Sprint: Dial Number: #777

Verizon: Dial Number: #777

AT&T: APN: isp.cingular

Alltel: Dial Number: #777

NOTE: Ensure your 3G wireless modem is activated before inserting into the NexConnect® router for use.

Gateway: http:// 192.168.1.1

Password: admin

The NexConnect® will support up to 253 IP addresses.

Yes, you can enable QoS.

Yes, you can enable remote management through Simple Network Management Protocol (SNMP).

Yes, you can enable remote administration. Select the Remote Admin icon under the Security section. Since most carriers use a Dynamic Public IP address, subscribe to a Dyn DNS service for public IP address resolution.

Yes, you can use a 3G modem card as a failover mechanism to your DSL or Cable connection.

Network Address Translation (NAT) translates multiple IP addresses on the private LAN to one public address that is sent out to the Internet. This adds a level of security since the address of a PC connected to the private LAN is never transmitted on the Internet.

Windows 2000, XP, Vista, Mac and Linux.

The NexConnect® router will support 5 concurrent VPN pass through sessions of IPsec.

IPsec provides either transport mode (end-to-end) security of packet traffic in which the end-point computers do the security processing, or tunnel mode (portal-to-portal) communications security in which security of packet traffic is provided to several machines by a single node.

Recent versions of Internet Explorer, Firefox, Safari, Opera, and Netscape.

Yes. The NexConnect® router has DHCP server software built-in.

When NexConnect® is powered on and working in normal status, using a straightened paperclip, press and hold the RESET button for about 20 seconds, until all the indicator lights turn off. Then release RESET button, press the RESET button to set up the device again.